After the grain crusher is sold, it will come with an instruction manual and operation manual. After the technical personnel have trained the demand side operators, the future use and maintenance of the ultrafine crusher must strictly follow the above two materials in order to maximize its service life.First, the corn grinder should be fixed on the ground, which can be fixed with cement. If the workplace frequently changes, the crusher and electric motor should be installed on a machine base made of angle steel. After installation, carefully check whether the installation is in place and whether there are any insufficiently secure installations. Check if the motor shaft and crusher shaft are parallel, and also check if the tension of the drive belt is appropriate.
Before starting the corn crusher, rotate the rotor by hand to check whether the operation is flexible and normal, whether there is collision in the casing, whether the rotation direction of the rotor is correct, and whether the motor and the crusher are well lubricated. Do not replace the pulley frequently to prevent the speed from being too high or too low. After starting, it should idle for 2 to 3 minutes without any abnormal phenomena before feeding.
The feeding of the corn grinder shall be even. If there is noise, the temperature of the bearing and the machine body is too high or the material is sprayed out, the machine shall be stopped immediately for inspection and troubleshooting.
Before starting work, the staff should carefully inspect the materials to prevent hard objects such as metals and stones from entering the crushing room and causing accidents. When feeding, the staff should stand at the side of the corn grinder to avoid being injured by the ejected sundries. When crushing long stems, do not grip your hands too tightly to prevent them from being carried in.
Stop feeding before stopping the machine, and after the materials in standby mode are completely discharged, cut off the power and stop the machine. Cleaning and maintenance should be carried out after shutdown. After 300 hours of homework, the bearings must be cleaned and the engine oil replaced; When installing engine oil, it is recommended to fill 1/3 of the bearing seat gap, and not exceed 1/2 at most. When stopping for a long time, the drive belt should be removed.
That's all for the introduction of Sichuan crushers above. I hope it's helpful to everyone